- 3 -
CAUTION
Data stored in the internal memory cannot be stored permanently. We will not be re-
sponsible for damages and lost profits caused by loss of data attributed to battery con-
sumption, trouble, repair, and so on.
Never disassemble or modify this instrument. It could cause a fire, electric shock, or
other problems.
● Do not insert foreign substances such as fingers, pens, wire, or paper into this in-
strument. It could damage the instrument or cause a fire.
● Use correct supply voltage. Other voltage level could damage the instrument.
● Do not splash water or chemicals on the instrument. If water gets inside the in-
strument, disconnect a power plug immediately from a plug socket and contact your
dealer/distributor for a repair. It could damage the instrument or cause a fire or
electric shock.
● Do not put paper or cloth on the instrument. It could cause a fire.
● Do not place any heavy material on a power cord. It could cause damage or a fire.
● Never touch a metallic part of the instrument.
● Never touch a printer head. It is very hot just after printing and you could get
burned. Also, dirt on your hand could cause trouble to the printer head.
● When the instrument is not going to be operated for a long period of time, be sure to
disconnect a power cord from a power socket for your safety.
● When disconnecting a power cord, be sure to hold a power plug. Do not pull on the
power cord, or the cord could be broken and cause a fire or electric shock.
ACCESSORIES
This instrument comes with the following accessories. Confirm that they are included before
using the machine.
1. Instruction manual 2. “Key-Card”
: 1 booklet : 10-pcs.
3. Screws for wall mounting
: 4-pcs.
(Only for ER-2500R)
Wire for external time signal
: 1 pc.
To Next Page
Loading...
