SAFETY INSTRUCTIONS2 - 4
DSE-15 www.maxcess.euMI 1094 1
Preventing hazards – No changes may be made to the sensor.
– The parameters specified in Section
Technical Data
must be
observed.
– Only accessories and replacement parts that have been
approved by Fife Tidland may be used.
– The sensor may not be used as a support, handle or step.
There is a danger that the sensor will become damaged
(breaking off/snapping), resulting in personal injury.
Residual risks Installing the product in a machine/system makes it possible to
form clamping, squeezing and cutting points.
Despite a safe design and supplementary protective measures,
residual risks may remain for the machine/system in which the
product is installed. These risks must be recorded in a risk
assessment by the machine/system builder and taken into
consideration in the operating instructions.
To Next Page
Loading...
