INTRODUCTION1 - 1
DSE-15 www.maxcess.euMI 1094 1
1 INTRODUCTION
About these operating
instructions These Operating Instructions describe the installation,
operation, commissioning, and maintenance of the DSE-15
sensor and provide important instructions for proper use.
The operating instructions must be carefully stored and must
always be available at or near the customer's system during the
service life of the sensor.
Translation of the original Operating Instructions:
These Operating Instructions are a translation. The original
Operating Instructions were composed in German.
Target groups These Operating Instructions are directed to both the
system
construction
master
as well as the
operator
who uses the sensor
in production line.
Read operating instructions
The Operating Instructions must be read and used by
all persons
who have the responsibility of installing, commissioning,
operating and maintaining the sensor.
Proper usage The digital reflected light sensor D
SE-15
is used for non-
contact measurement of the lateral offset of a material web
being guided in a customer system. The sensor is suitable for
– Web edge guiding and
– Web center guiding for dual application.
The sensor can be used to control opaque , transparent or
reflective materials.
The sensor must only be used in accordance with its intended
purpose and in a technically flawless conditions.
The sensor must not be changed or opened.
To Next Page
Loading...
Need help?
General
