INTRODUCTION1 - 3
DSE-15 www.maxcess.euMI 1094 1
It is possible to operate the sensor with either a supply voltage
of 12V or 24V. The output signal would automatically be
switched over in that case.
– Power supply voltage 12V:
The sensor provides an output signal in the range from 0 to
10mA. Thus the sensor can be connected to all Fife web
guide controllers.
– Power supply voltage 24V:
The sensor provides an output signal in the range from 4 to
20mA. This can be used to establish a wire-break-proof
connection to external devices.
An integrated LED display shows information about operation
states directly on the sensor, for example whether supply
voltage is applied, the cover of the red light beam and error
messages.
Option A digital production data acquisition to Fife D-MAXE controller
extends the range of applications for the sensor inside the
digital network environment. Additional sensor data can be
provided to other hardware equipment if the Fife D-MAXE is
linked appropriately to the network.
To Next Page
Loading...
Need help?
General
