Maxcom MM35D User Manual

13
If the process of charging is complete, there will be a
message on the display „Battery fully charged”, and the
battery icon will stop blinking.
DESKTOP CHARGER
In case of using a desktop charger, first you need to connect
the charger with a desktop charger, and then plug it into a
power outlet. To charge the battery, all you need to do is to
place the phone on the desktop charger with contact pins
downwards.
Important:
o Prior to charging make sure the battery is installed
correctly
o Never remove the battery while charging – you
might damage the phone
o If the voltage is too low for the phone to work
properly, a warning message will appear on the
display that the phone will be automatically
switched off, and the phone will be switched off.
o If the battery is deeply discharged, it might take up
to several minutes for the message to appear after
the charger is plugged in.
o If the phone was not used for a long time, the
battery might be so called “deeply discharged”; to
recover a deeply charged battery you should leave
the battery connected although there is no
message on the display. It might take up to an hour
for the message to appear.
LOW BATTERY ALERT
The phone will beep (if warning alerts are enabled in profile)
and a message „Battery discharged” will appear on the

Maxcom MM35D Specifications

General

Brand	Maxcom
Model	MM35D
Category	Telephone
Language	English