5-10t Internal Combustion Counterbalance Forklift Truck Operation & Maintenance Manual
3.7 Notices during Failure Occurrence with Forklift Truck
Attention must be paid to the following requirements, when forklift truck cannot run due to its
own failure and other equipment is needed to drag it:
(1) Demount the drive shaft between transmission and speed differential.
(2) Place the gear-shift lever at the middle position (neutral gear).
This is because the oil feed pump cannot perform normal lubrication when it is out of service,
and it may possibly give rise to adhesion, if rotation of drive wheel is transmitted to the gear
of transmission and the clutch. (Hence the drive shaft shall be detached.)
3.8 Failure Removal
(1) Insufficient Power: Refer to Table 3-2.
(2) Abnormal Rise of Oil Temperature: Refer to Table 3-3.
(3) Loud Noise with Transmission: Refer to Table 3-4.
(4) Low Transmission Efficiency: Refer to Table 3-5.
(5) Oil Leak; Refer to Table 3-6.
To Next Page
Loading...