17
2. Use runner switch to raise (UP)
platform from ground level to
bed height (FIG. 17-1). Release
switch when platform reaches
bed height.
FIG. 17-2
4. Use runner switch to lower
the platform to ground level
(FIG. 17-2).
5. If there are more loads to put
in vehicle, repeat the previous
LOADING VEHICLE steps
for each load. When loading
is fi nished, use STOWING
PLATFORM procedure in
this manual.
INBOARD
EDGE
RUNNER
SWITCH
DOWN
3. Unhook chain from platform
railing as shown in FIG. 17-
1A. Carefully move the load
into vehicle (FIG. 17-1).
MOVING LOAD INTO VEHICLE
FIG. 17-1
RUNNER
SWITCH
UP
FIG. 17-1A
CHAIN
HOOK
CHAIN
PLATFORM
RAILING
To Next Page
Loading...
