20
INBOARD
EDGE
A load should never extend past the edges of the platform. Do not
place unstable loads on platform and do not allow load to exceed
lifting capacity of Liftgate. Load must not exceed maximum of 3
cylinders on each side of platform within the rated Liftgate capacity.
If standing on platform, do not allow your feet to extend beyond
inboard edge of platform.
WARNING
!
POSITIONING LOAD
PUSHING LOAD ON PLATFORM
FIG. 20-1
Pulling the load from vehicle to platform can result in a fall from
platform and serious injury. When unloading vehicle, always push
the load out on the platform.
2. Wrap chain around each gas
bottle and hook onto platform
railing as shown in FIG.
20-1A. If standing on platform
with the load, stand in the
footprint area shown (FIG.
20-1) and comply with the
preceding WARNING.
1. Place all loads as close as
possible to the inboard edge
of the platform with heaviest
part toward the truck body
as shown in FIG. 20-1. Make
sure load rests against
platform railing (FIG.20-1)
and angle support (FIG. 20-
1B).
FIG. 20-1A
!
WARNING
CHAIN
FIG. 20-1B
ANGLE
SUPPORT
GAS
BOTTLE
CHAIN
HOOK
CHAIN
PLATFORM
RAILING
UNLOADING VEHICLE - Continued
To Next Page
Loading...
