Maxon TE-33 - Step 9 - Connect Power Cable to Battery

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
45
STEP 9 - CONNECT POWER CABLE TO BATTERY
1. Remove nut from negative (-) bat-
tery terminal. Disconnect negative
(-) battery cable (FIG. 45-1).
DISCONNECTING (-) BATTERY CABLE
FIG. 45-1
NOTE: MAXON recommends using dielectric grease on all electrical connections.
NEGATIVE (-)
BATTERY TERMINAL
NEGATIVE (-)
BATTERY CABLE
RECONNECTED BATTERY CABLES
FIG. 45-3
POSITIVE (+)
BATTERY TERMINAL
POSITIVE (+)
BATTERY CABLE
NUT
NUT
2. Remove nut from positive (+)
battery terminal (FIG. 45-1).
3. Connect fused positive (+) cable
to positive (+) battery terminal
(FIG. 45-2). Then, reinstall nut
on positive (+) battery terminal
(FIG. 45-3).
4. Reconnect negative (-) battery
cable to negative (-) battery ter-
minal (FIG. 45-2). Then, reinstall
nut on negative (-) battery termi-
nal (FIG. 45-2).
CONNECTING FUSED (+) CABLE
FIG. 45-2
POSITIVE (+)
BATTERY TERMINAL
FUSED (+)
CABLE
NEGATIVE (-)
BATTERY CABLE
NEGATIVE (-)
BATTERY TERMINAL
NUT
NUT