11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
46
CAUTION
Do not fully pressurize the system in this step. Fully pressurize the system and
check for hydraulic leaks after Liftgate is fully welded.
FIG. 46-1
FIG. 46-2
FLOOR JACK
BRACKET & FASTENERS
(2 PLACES)
EXTENSION PLATE
1. Push control switch to UP position and hold just enough time to pressurize hydraulic
system. Release control switch. Hydraulic system is ready.
2. Remove fl oor jack and hoist
supporting Liftgate (FIG. 46-1).
3. Lower platform to the ground.
Remove both installation brackets
from extension plate (FIG. 46-2).
STEP 10 - REMOVE LOCKING BRACKETS & CHECK
FOR INTERFERENCE
To Next Page
Loading...
