Maxon TE-33 - Page 54

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
54
STEP 12 - ADJUST PLATFORM (IF REQUIRED)
- Continued
3. Make sure platform is still at ground
level. If the tip of fl ipover is not touching
the ground, measure and compare dis-
tance “B” (FIG. 54-1) with TABLE 54-1
to determine how much to grind from
the platform stops (FIG. 54-3).
TABLE 54-1
LOWER TIP OF
FLIPOVER
THIS DISTANCE “B”
GRIND METAL FROM
PLATFORM STOP
7/8” 1/16”
2” 1/8”
3” 3/16”
3-15/16” 1/4”
PLATFORM DOES NOT
TOUCH GROUND
FIG. 54-1
4. RAISE the platform to comfortable work
height. Fold fl ipover and platform for access
to platform stops (FIG. 54-2).
GRINDING PLATFORM STOPS
(CURBSIDE SHOWN)
FIG. 54-3
TIP OF
FLIPOVER
“B”
(TABLE 54-1)
PLATFORM
STOP
GRIND HERE
(TABLE 54-1)
6. Unfold fl ipover and platform. LOWER plat-
form to the ground. As the platform fi rst
touches the ground, the tip of fl ipover and
shackle should touch at the same time as
shown in FIG. 54-1.
5. Grind correct amount of metal (TABLE 54-1)
from platform stop as shown in FIG. 54-3.
PLATFORM RAISED TO WORK HEIGHT
FIG. 54-2