P1
P5
P9
P2
P6
P11
P10
P3
P7
P12
P4
P8
Step 1: Program Selection
knob clockwise / anti-clockwise.
Step 2: Setting the Training Level
the control knob.
Step 3: Setting the Training Time
You
can set the exercise time from 1:00 to 99:00 minutes in 1-minute increments.
Step 4: Training Start
Press the START / STOP key to start exercising.
Training End
When the desired training time has been reached, training will end automatically.
Setting the Training Level
During training, you can change the currently selected training level within the given frame by turning control knob clock-
wise / anti-clockwise at any time.
Connecting the Device
Always connect the mains adapter to the training device before plugging it into a power socket.
When disconnecting the training device from the mains, remember to unplug the mains adapter from the socket first.
CAUTION:
Before connecting the training device to the mains adapter, always ensure that you are using the correct mains adapter intended for
the training device. Mains adapters with the wrong voltage can severely damage the electronics of the device. It is recommended to
mark the mains adapter of the exerciser to avoid confusion.
Switching on the Device
As soon as the training device is connected to the mains, it switches on automatically. If the exerciser is in standby mode, switch it
on by pressing a button on the Cockpit or by moving the pedal.
Switching off the Device
If the device is not used for approximately 4 minutes after the training session, the standby mode is automatically activated. For
optimal safety and energy efficiency, it is recommended to disconnect the training device from the power supply when not in use.
19
Mains Adapter
Take the connection cable of the mains adapter (D08) included in the delivery. Plug the connection cable into the socket on
the front of the main frame (A01). Then, connect the mains adapter (D08) to a power socket.
CAUTION:
This device should only be connected to an earthed socket that has been installed by a qualified electrician. Do not use
a socket strip for the connection. If an extension cable is necessary, ensure that it complies with the VDE regulations and
guidelines.
Connecting the Device
CAUTION:
Before connecting the mains adapter to the device, always ensure that you are using the mains adapter supplied specifically
with the device. Using a different mains adapter may result in damage to the electronic components, for which
the manufacturer cannot be held liable.
When connecting the device to the power supply, always connect the power cable to the exerciser first before plugging it
into a power outlet. Likewise, when disconnecting the exerciser from the power supply, always disconnect the power cable
from the mains first.
Switching on the Device
First connect the power cable to the exerciser and then connect the mains cable to the power socket, the cockpit turns on
automatically. If the training device is already connected to the mains, but the cockpit is in stand-by
mode, activate the cockpit by pressing any key or by moving the pedals.
Turning off the Device
When inactive for more than 4 minutes, the cockpit automatically switches to stand-by mode. Once you have finished your
workout you should always disconnect the exerciser from the mains. Always unplug the mains cable from the wall socket
first and then remove the power cable.
Mains Connection
Cockpit
To Next Page
Loading...
Need help?
General
