516532 B PUBLICATION DATE 1 JUN 2007.DOC PROGRAMMING MANUAL 23
6. OPERATION MENU
6.1. STARTING UP
ATTENTION
!!!
BEFORE STARTING UP THE FIRST TIME, BE SURE THAT THE MACHINE IS PROPERLY INSTALLED.
SEE INSTALLATION MANUAL.
ATTENTION
!!!
WASH CYCLES CAN ONLY BE STARTED WHEN THE KEY SWITCH IS IN RUN MODE.
6.2. SWITCHING ON THE POWER
) The display lights up when you switch on the power.
The Price of the wash cycle is shown. (There are different Pricing modes, see Price Menu.)
If the cycle is ready to be started (Cycle price Paid), SELECT CYCLE is displayed.
6.3. LOAD THE WASHING MACHINE
) Open the door and load the laundry into the drum. When the drum is loaded, close the door.
6.4. PUT SOAP INTO THE SOAP DISPENSER
) Put the correct amount of soap into the soap dispenser, compartments A & B.
) Put the correct amount of softener into the soap dispenser, compartment C.
6.5. PAY
)
Insert coins until „SELECT CYCLE“ is displayed.
) Use the Debit Card for the payment procedure until „SELECT CYCLE“ is displayed.
6.6. START WASH CYCLE
)
Press one of the 6 wash cycle buttons to START the wash cycle.
If the door is not closed, the message „CLOSE DOOR“ will be shown.
) Close the door and Press one of the 6 wash cycle buttons to START the wash cycle.
If you have selected the wrong cycle.
) The cycle can be changed until the first fill of the cycle is completed.
6.7. THE ACTIVE PROGRAM
The cycle time will decrease minute by minute and gives an approximate indication of how long it
will take before the cycle is finished. Fill time is not included in estimate.
101008
!
!
To Next Page
Loading...
Need help?
General
