Maytronics Dolphin Wave User Manual

6
Removing the Robot from the Swimming Pool:
1. Press HOME.
The robot starts moving in the direction of the floating cable.
2. Holding the floating cable, gently pull the robot upwards and towards the Caddy.
As it reaches the side of the pool, pull the cable gently until the floating cable
handle emerges. Grasp the handle, tilting the robot slightly allowing water to
drain, place by the pool side, or guide it onto the Caddy. The robot shuts down
automatically.
Manual Stop Control
If necessary, you can stop the robot during the cleaning session.
1. From the countdown screen (Figure 4), press Stop. The MMI screen
displays the message: "Stopping robot – please wait".
After 5 seconds the Manual Stop screen is displayed (Figure 6).
Manual Stop
exit
Completed Time
Filter Bag
Total Hours
01:20
Clean
Figure 6: Manual Stop screen
2.
To stop the cleaning session completely, press Exit. The MMI display
returns to the Wave screen.
MMI Alerts
Filter bag: LED will illuminate when the filter bag is full and needs
replacement/cleaning at the end of the cleaning cycle. Does not require immediate
stop of operation. LED indication will automatically reset on next operation with
clean bag.
Alert: LED will illuminate as an indication of an error that stops the robot.
Generally inspect the robot and re-operate. If the error is consistent - details of the
Filter Bag
Alert
specific error will be displayed on the MMI screen. Refer to Troubleshooting
instructions on page 17.
6
Removing the Robot from the Swimming Pool:
1. Press HOME.
The robot starts moving in the direction of the floating cable.
2. Holding the floating cable, gently pull the robot upwards and towards the Caddy.
As it reaches the side of the pool, pull the cable gently until the floating cable
handle emerges. Grasp the handle, tilting the robot slightly allowing water to
drain, place by the pool side, or guide it onto the Caddy. The robot shuts down
automatically.
Manual Stop Control
If necessary, you can stop the robot during the cleaning session.
1. From the countdown screen (Figure 4), press Stop. The MMI screen
displays the message: "Stopping robot – please wait".
After 5 seconds the Manual Stop screen is displayed (Figure 6).
Manual Stop
exit
Completed Time
Filter Bag
Total Hours
01:20
Clean
Figure 6: Manual Stop screen
2.
To stop the cleaning session completely, press Exit. The MMI display
returns to the Wave screen.
MMI Alerts
Filter bag: LED will illuminate when the filter bag is full and needs
replacement/cleaning at the end of the cleaning cycle. Does not require immediate
stop of operation. LED indication will automatically reset on next operation with
clean bag.
Alert: LED will illuminate as an indication of an error that stops the robot.
Generally inspect the robot and re-operate. If the error is consistent - details of the
Filter Bag
Alert
specific error will be displayed on the MMI screen. Refer to Troubleshooting
instructions on page 17.

Maytronics Dolphin Wave Specifications

General

Brand	Maytronics
Model	Dolphin Wave
Category	Swimming Pool Vacuum
Language	English