15
from the power supply, unroll the entire cable and re-arrange it on the Caddy's
handle as required.
6. Preventive Maintenance (PM): should be performed on the Wave
robot pool cleaner, in order to keep it in good and long lasting working
condition. MAYTRONICS provides the parts required – as a dedicated
PM kit. The work and the service will be provided through the dealer.
PM service should be performed every 1,500 working hours or 1 year
(the earlier of the two).
7. A warning message to perform PM will appear on the MMI screen,
when applicable. It is obligatory that PM service will be performed.
Please contact your dealer. Failure to perform the PM service will void
the warranty.
Remote Control Unit
The remote control unit (RCU) is located on the MMI console and held in
position by a magnet. Pull it upwards gently to remove it from its base. When
the robot is in automatic operation, use the remote control to override the
robot’s programmed direction settings.
When the robot is moving in a forward direction, the floating cable
follows the robot from its tail end.
The remote unit has a control range of 50 meters from the Caddy.
Figure 14: Remote Control Unit
15
from the power supply, unroll the entire cable and re-arrange it on the Caddy's
handle as required.
6. Preventive Maintenance (PM): should be performed on the Wave
robot pool cleaner, in order to keep it in good and long lasting working
condition. MAYTRONICS provides the parts required – as a dedicated
PM kit. The work and the service will be provided through the dealer.
PM service should be performed every 1,500 working hours or 1 year
(the earlier of the two).
7. A warning message to perform PM will appear on the MMI screen,
when applicable. It is obligatory that PM service will be performed.
Please contact your dealer. Failure to perform the PM service will void
the warranty.
Remote Control Unit
The remote control unit (RCU) is located on the MMI console and held in
position by a magnet. Pull it upwards gently to remove it from its base. When
the robot is in automatic operation, use the remote control to override the
robot’s programmed direction settings.
When the robot is moving in a forward direction, the floating cable
follows the robot from its tail end.
The remote unit has a control range of 50 meters from the Caddy.
Figure 14: Remote Control Unit
To Next Page
Loading...
Need help?
General
