To Next Page

To Previous Page

Coarse filter bags are added as an option, to be used to collect large

debris.

Should also be used in cases of sand accumulations in the pool.

Customized Settings

The Dolphin Wave robot is controlled from the MMI console. You can

customize the robot's settings to match the specific type of swimming pool that

is to be cleaned. Four different swimming pool configurations can be set and

stored in the MMI's memory for future use.

When you configure the pool profile, you can also set the cleaning-cycle time

and the delay time before the robot starts its cleaning cycle. The procedure for

configuring additional pool profiles is explained in Configuring Additional

Pool Profiles on Page 9.

The MMI keyboard procedures are explained in the next section.

MMI Operations

Use the control buttons

located on the MMI below the screen, to

activate the various commands.

Use the MMI functions that appear in the various screen displays to navigate

between the screens and to configure the software.

MMI Functions:

Command Description

From the opening screen press Menu to

display the Main Menu.

▲

Scroll up.

▼

Scroll down.

Start

Press both green buttons simultaneously to

Start pool cleaning.

Select

Press Select to confirm your selection after

using the scrolling buttons.

Modify

Press Modify to change settings after making

a selection.

Back

Press to return to the previous screen.

Exit

Press to return to the Wave screen.