EasyManuals Logo

Maytronics Dolphin Wave User Manual

Maytronics Dolphin Wave
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
III
FCC statement
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party
responsible for compliance (Maytronics Ltd.) could void the user’s authority to
operate the equipment.
General Notes
In this user manual, the instruction press "Start" is performed by pressing both
green buttons -
- simultaneously on the MMI (Figure 2).
The MMI is equipped with a screensaver that comes into effect after 5 minutes
idle time. Press Pool and Home in that order to unlock the MMI console.
Some options in the MMI menus are blocked by code, in order to prevent un-
necessary changes of settings. The code is the following key sequence:
3 2 1
III
FCC statement
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this equipment not expressly approved by the party
responsible for compliance (Maytronics Ltd.) could void the user’s authority to
operate the equipment.
General Notes
In this user manual, the instruction press "Start" is performed by pressing both
green buttons -
- simultaneously on the MMI (Figure 2).
The MMI is equipped with a screensaver that comes into effect after 5 minutes
idle time. Press Pool and Home in that order to unlock the MMI console.
Some options in the MMI menus are blocked by code, in order to prevent un-
necessary changes of settings. The code is the following key sequence:
3 2 1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Maytronics Dolphin Wave and is the answer not in the manual?

Maytronics Dolphin Wave Specifications

General IconGeneral
BrandMaytronics
ModelDolphin Wave
CategorySwimming Pool Vacuum
LanguageEnglish

Related product manuals