Maytronics Dolphin Wave User Manual

12
8. Set Navigation Mode and choose either Rectangular 1 (Default),
Rectangular 2, or Shaped.
Rectangular 1
- Recommended for pools with parallel walls, and 90º 'L'
shape.
Rectangular 2- as above, in case magnetic interference that cause
curved motion.
Shaped- Recommended for free formed pools.
9. Set Scanning Path and choose either Default Lines to Right or Lines to
Left.
Default- Recommended.
Lines to Right / Left- To be used in cases when the pool scan needs to
be limited to one direction or split into two sections.
In order to use this mode, consult your dealer.
10. After setting the Scanning Path, from the Pool Profile screen, scroll
down to the next screen to "Direction Setup" (Figure 13).
Figure 13: Second pool profile screen
11. Press Select to enter Direction Setup.
12. To change the Direction Setup, proceed as explained in Manual
Direction Setup below.
13. Press Select to enter Delay Time.
Setting a Delay Time allows you to delay the start of cleaning
operations by a time factor selected from the MMI screen.
To override the Delay Time instruction, from the Wave screen press
Start.
Pool A Profile
select
c
d
back
Direction Setup
Reset Pool A profile
Line Spacing
Delay Time
180.0
Medium
0 h
12
8. Set Navigation Mode and choose either Rectangular 1 (Default),
Rectangular 2, or Shaped.
Rectangular 1
- Recommended for pools with parallel walls, and 90º 'L'
shape.
Rectangular 2- as above, in case magnetic interference that cause
curved motion.
Shaped- Recommended for free formed pools.
9. Set Scanning Path and choose either Default Lines to Right or Lines to
Left.
Default- Recommended.
Lines to Right / Left- To be used in cases when the pool scan needs to
be limited to one direction or split into two sections.
In order to use this mode, consult your dealer.
10. After setting the Scanning Path, from the Pool Profile screen, scroll
down to the next screen to "Direction Setup" (Figure 13).
Figure 13: Second pool profile screen
11. Press Select to enter Direction Setup.
12. To change the Direction Setup, proceed as explained in Manual
Direction Setup below.
13. Press Select to enter Delay Time.
Setting a Delay Time allows you to delay the start of cleaning
operations by a time factor selected from the MMI screen.
To override the Delay Time instruction, from the Wave screen press
Start.
Pool A Profile
select
c
d
back
Direction Setup
Reset Pool A profile
Line Spacing
Delay Time
180.0
Medium
0 h

Maytronics Dolphin Wave Specifications

General

Brand	Maytronics
Model	Dolphin Wave
Category	Swimming Pool Vacuum
Language	English