Maytronics Dolphin Wave - Page 25

18
Error Message Check Action to Take
Robot is stuck on
pool floor
1. Has the robot
stopped on an
obstacle?
2. Is there an
obstruction in the
water channel or in
the robot's driving
belts?
Move the robot from its position and remove
the obstacle. Reactivate.
If this re-occurs, contact the Maytronics
dealer/distributor.
Navigation System Does the problem
re-occur on every
operation?
Contact the Maytronics dealer/distributor.
Fuse Fail Is there an electrical
short or rupture in the
floating cable?
Repair cable and replace the fuse.
Note: The fuse holder is located beneath the
power supply on the right hand side.
Replace the fuse with the spare provided.
Note: This is a special fuse and a
replacement can be obtained from your
Maytronics dealer.
No Communication Does the problem
occur when pressing
POOL or HOME on
the MMI?
Contact the Maytronics dealer/distributor.
Note: You can work temporarily without
using the MMI.
Disconnect it from the power supply thus
disabling the Pool/Home function.
18
Error Message Check Action to Take
Robot is stuck on
pool floor
1. Has the robot
stopped on an
obstacle?
2. Is there an
obstruction in the
water channel or in
the robot's driving
belts?
Move the robot from its position and remove
the obstacle. Reactivate.
If this re-occurs, contact the Maytronics
dealer/distributor.
Navigation System Does the problem
re-occur on every
operation?
Contact the Maytronics dealer/distributor.
Fuse Fail Is there an electrical
short or rupture in the
floating cable?
Repair cable and replace the fuse.
Note: The fuse holder is located beneath the
power supply on the right hand side.
Replace the fuse with the spare provided.
Note: This is a special fuse and a
replacement can be obtained from your
Maytronics dealer.
No Communication Does the problem
occur when pressing
POOL or HOME on
the MMI?
Contact the Maytronics dealer/distributor.
Note: You can work temporarily without
using the MMI.
Disconnect it from the power supply thus
disabling the Pool/Home function.