Mazda 13B-MSP - Tension Bolt Disassembly Note; Rear Housing Disassembly Note; Stationary Gear Disassembly Note; Tubular Dowel Disassembly Note

MECHANICAL
01–10–10
Engine Workshop Manual 13B-MSP (Multi Side Port) (1773–1U–03C)
Tension Bolt Disassembly Note
1. Loosen the tension bolts in 2⎯3 passes in the
order shown in the figure and remove them.
Rear Housing Disassembly Note
1. Move the rear housing to the left and right to cut the oil film.
2. Remove the rear housing.
Caution
• If a seal adheres to the rear housing, put
it back in its original position in the rotor.
Stationary Gear Disassembly Note
1. Remove the stationary gear using the SST.
Tubular Dowel Disassembly Note
1. Remove the tubular dowel using the SST.
9
8
7
5
4
3
10
18
17
15
16
14
13
11
12
6
1
2
BHJ0110E013
SEAL
CHU0110E039
49 0813 235
BHJ0110E016
49 0813 215A
BHJ0110E017