Mazda 13B-MSP - Front Cover Assembly Note; Pulley Lockbolt Assembly Note

MECHANICAL
01–10–44
Front Cover Assembly Note
1. Before installing the front cover, install the pulley
boss to the eccentric shaft and measure the
height between the eccentric shaft top and the
pulley boss.
• If not within the specification, verify that the
spacer is not caught in the needle bearing.
Standard
10.34—11.14 mm {0.4071—0.4385 in}
2. Tighten the engine front cover installation bolts in
the order shown in the figure.
Tightening torque
18.6—25.5 N·m
{1.90—2.60 kgf·m, 13.8—18.8 ft·lbf}
Pulley Lockbolt Assembly Note
1. Lock the flywheel (MT) or counterweight (AT)
against rotation using the SSTs.
2. Apply engine oil to the pulley lockbolt threads.
3. Assemble a new O-ring.
4. Apply silicone sealant to the seating face.
5. Tighten the pulley lockbolt.
Tightening torque
300—340 N·m
{30.6—34.6 kgf·m, 222—250 ft·lbf}
End Of Sie
10.34—11.14 mm
{0.4071—0.4385 in}
PULLEY BOSS
ECCENTRIC SHAFT
CHU0110E038
7
5
4
3
1
2
6
BHJ0110E098
MT
AT
49 1881 055A
49 F011 101
BHJ0110E007
O-RING
ENGINE OIL
SEALANT
SEALANT
CHU0110E066