Mazda 13B-MSP - Oil Pan Assembly

MECHANICAL
01–10–47
01–10
Engine Workshop Manual 13B-MSP (Multi Side Port) (1773–1U–03C)
Revised 6/2008 (Ref. No. R108/08)
Oil Pan Upper Block Assembly Note
Caution
• Apply the silicon sealant in a single, unbroken line around the whole perimeter.
• Install the oil pan upper block within 5 min after applying the silicone sealant.
• Using bolts with the old seal adhering
could cause cracks in the housing.
1. Completely clean and remove any oil, dirt, sealant
or other foreign material that may be adhering to
the oil pan upper block and housing.
2. When reusing the oil pan upper block installation
bolts, clean any old sealant from the bolts.
3. Apply silicone sealant to the areas as shown in
the figure.
Caution
• Apply silicone sealant to the outer
circumference of the bolt hole at
locations A shown in the figure.
Thickness
2.5—6.5 mm {0.10—0.26 in}
4. Install the oil pan upper block to the housing.
5. Tighten the oil pan upper block installation bolts.
Tightening torque
18.6—25.5 N·m {1.9—2.6 kgf·m, 13.8—18.8
ft·lbf}
Oil Pan Assembly Note
Type A
Caution
• Using bolts with the oil sealant still
adhering could cause cracks in the
housing. Clean all sealant off all oil pan
bolts before assembly.
• Apply the silicon sealant in a single,
unbroken line around the whole
perimeter.
• Install the engine front cover within 5 min
after applying the silicone sealant.
1. Completely clean and remove any oil, dirt, sealant
or other foreign material that may be adhering to
the housing and oil pan.
2. When reusing oil pan installation bolts, clean any old sealant from the bolts.
3. Apply silicone sealant to the areas shown in the
figure.
Bead thickness
2.5—6.5 mm {0.1—0.2 in}
4. Tighten the oil pan installation bolts.
Tightening torque
8.8—11.8 N·m
{90—120 kgf·cm, 78—104 in·lbf}
OLD SEALANT
DAMAGE
CHU0111W004
SEALANT
SEALANT
A
BHJ0110F010
OLD SEALANT
DAMAGE
CHU0111W004
SEALANT
SEALANT
BHJ0110E100