MECHANICAL
01–10–23
01–10
Engine Workshop Manual 13B-MSP (Multi Side Port) (1773–1U–03C)
Revised 6/2008 (Ref. No. R108/08)
3. Assemble the eccentric shaft pulley, eccentric
shaft position plate, pulley boss component apply
engine oil to the pulley lockbolt threads, and then
tighten.
Tightening torque
300—340 N·m {30.6—34.6 kgf·m, 222—250
ft·lbf}
4. Remove the SST.
5. Measure the end play of the eccentric shaft using
a dial gauge.
• If not within the specification, replace the
spacer with one that is thicker than the
currently assembled one. If it exceeds the
specification, replace with a thinner spacer.
Standard end play
0.04—0.09 mm {0.0016—0.0035 in}
Spacer types
(mm {in})
Note
• If the end play is not within the specification even after replacing with an A-marked spacer, adjust by
grinding it and reuse.
End Of Sie
PLATE
NEEDLE BEARING
THRUST PLATE
SPACER
NO GOOD
GOOD
CHU0110E019
BHJ0110E054
Marking Dimension
A 7.985 {0.3144}
B 8.005 {0.3152}
C 8.025 {0.3159}
D 8.045 {0.3167}
E 8.065 {0.3175}
To Next Page
Loading...