Mazda 3 2020 - Page 322

▼
Setting the System
Operation conditions
Headway control function
The CTS operates when all of the following conditions are met.

(Automatic transmission vehicle)

The vehicle speed is about 0 km/h (0 mph) to 200 km/h (125 mph)
*1
/145
km/h (90 mph)
*2
.

The selector lever is in the D or M position (manual mode).

(Manual transmission vehicle)

The vehicle speed is about 30 km/h (19 mph) to 200 km/h (125 mph)
*1
/145
km/h (90 mph)
*2
.

The shift lever is in a position other than the R or N position.

The clutch pedal is not depressed.

The CTS is operating.

The headway control function of the Mazda Radar Cruise Control (MRCC) or
Mazda Radar Cruise Control with Stop & Go function (MRCC with Stop & Go
function) is set to operable (if it was set to inoperable, set it to operable using the
personalisation function).

The brake pedal is not depressed.

The parking brake is released (Electric Parking Brake (EPB) indicator light is turned
o).

There is no problem with the DSC.

All the doors are closed.

The driver's seat belt is fastened.
*
1 European models
*
2 Except European models
NOTE
(Automatic transmission vehicle)

Under the following conditions, the CTS cannot be used when the vehicle speed is
30 km/h (19 mph) or slower.

There is a problem with the stop hold control function.

There is a problem with the Electric Parking Brake (EPB).

The CTS may not launch directly after the engine starts.
When Driving
i-ACTIVSENSE
4-164
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36