Steering assist function
The steering assist function operates when all of the following conditions are met.
Your vehicle is moving and less than about 55 km/h (34 mph).
White (yellow) lane lines on both sides are detected and you are driving near the
centre of the lane, or your vehicle detects a vehicle ahead.
The steering wheel is not turned sharply.
The direction indicator lever is not operated.
The headway control function is operating.
(Manual transmission vehicle)
The vehicle speed is about 30 km/h (19 mph) or faster.
NOTE
The steering assist function operates so that the vehicle remains near the centre of
the driving lane, however, depending on conditions such as the road curvature, road
slope and undulations, and vehicle speed, the function might not be able to keep
the vehicle near the centre of the driving lane.
Setting method
1. CANCEL switch
2. RES switch
3. CTS switch
1. Press the CTS switch.
The CTS standby indication (white) turns on. In addition, the CTS display
indication is displayed on the multi-information display at the same time.
2. Adjust the vehicle speed to the desired setting using the accelerator pedal and
press the RES switch up (SET+) or down
(SET)
to start headway control.
When Driving
i-ACTIVSENSE
4-165
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36
To Next Page
Loading...
