11.Move the wipers to their initial
positions using the following
procedure.
a) Make sure that the wipers are set
on the windscreen.
b) Switch the ignition ON.
c) Press up the wiper switch to the
MIST position 1 time.
When the procedure is
completed, the wipers operate
and they stop at the initial
positions.
▼
Replacing Rear Window Wiper
Blade (Hatchback)
When the wiper no longer cleans well,
the blade is probably worn or cracked.
Replace it.
CAUTION
To prevent damage to the wiper arm
and other components, do not move
the wiper by hand.
1. Raise the wiper arm and rotate the
wiper blade to the right until it
unlocks, then remove the blade.
CAUTION
To prevent damage to the rear
window, do not let the wiper arm
fall on it.
2. Pull down the blade rubber and
slide it out of the blade holder.
3. Remove the metal
stieners
from
the blade rubber and install them in
the new blade.
CAUTION
Do not bend or discard the
stieners. You need to use them
again.
Maintenance and Care
Owner Maintenance
6-37
Mazda3_8HS5-EE19I_Edition1_new 2019-7-1 10:56:36
To Next Page
Loading...
