▼
Shift-up/Shift-down Request Display (Manual Transaxle)
The shift-up or shift-down request display in the active driving display may be indicated
while the MRCC is operating. When this occurs, shift gears because the gear position is not
appropriate.
Request Display
Shift up
Shift down
NOTE
If the gears are not shifted up even though the shift-up request indication is displayed, load
will be applied to the engine and the MRCC system may be automatically cancelled or
engine damage could occur.
▼
Cruise Control Function
While this function is operating, the
headway control operation is cancelled
and only the cruise control function
operates.
The vehicle speed can be set more than
about 25 km/h (16 mph).
Use the cruise control function on
expressways and other highways which do
not require a lot of repeated acceleration
and deceleration.
WARNING
Do not use the cruise control function in
the following locations:
Otherwise, it could lead to an accident.
¾Roads with sharp curves and where
vehicle
trac
is heavy and there is
insucient space between vehicles.
(Driving under these conditions using the
cruise control function is not possible)
¾Steep down slopes (Set speed may be
exceeded because sucient engine
braking cannot be applied)
¾Slippery roads such as ice or snow-bound
roads (Tyres could spin causing you to
lose vehicle control)
Always drive carefully:
The warnings and brake control will not
operate after the headway control function
is cancelled and the system is switched to
only the cruise control function. Depress
the brake pedal to decelerate according to
the surrounding conditions while keeping a
safer distance from the vehicle ahead and
always driving carefully.
When Driving
i-ACTIVSENSE
4-149
CX-3_8GT4-EE-18D_Edition8_old 2019-11-14 12:53:52
To Next Page
Loading...
