NOTE
In the following cases, the warnings and brakes may not operate even if your vehicle starts
closing in on the vehicle ahead.
x
You are dr ivin g yo u r vehicl e at t he same spe ed a s t h e v ehic l e a h ead .
x
Directly after the MRCC with Stop & Go function system has been set.
x
Directly after the accelerator pedal is released.
x
Another vehicle cuts into the driving lane.
▼
Setting the System
The MRCC with Stop & Go function system operates when all of the following conditions
are met.
x
The vehicle speed is as follows:
x
(European models)
About 0 km/h (0 mph) to 200 km/h (124 mph)
x
(Except European models)
About 0 km/h (0 mph) to 145 km/h (90 mph)
x
The MRCC with Stop & Go function is turned on.
x
The brake pedal is not depressed.
x
The electric parking brake (EPB) is released (electric parking brake (EPB) indicator light
is turned off).
x
There is no problem with the DSC.
x
All the doors are closed.
x
The driver's seat belt is fastened.
x
The selector lever is in the drive (D) position or manual (M) position (manual mode).
NOTE
x
In the following cases, the MRCC with Stop & Go function system is cancelled when the
vehicle is travelling at 30 km/h (20 mph) or less and “MRCC Disabled < 30 km/h (20
mph)” is displayed in the active driving display.
x
The Forward Sensing Camera (FSC) cannot detect target objects (There is problem
with the Forward Sensing Camera (FSC) or windscreen is dirty).
x
There is a problem with the stop hold control function.
x
There is a problem with the electric parking brake (EPB).
x
It may not be possible to set the MRCC with Stop & Go function system directly after
starting the engine, while the DSC operation is being checked.
When Driving
i-ACTIVSENSE
4-155
CX-3_8GT4-EE-18D_Edition8_old 2019-11-14 12:53:52
To Next Page
Loading...
