Mazda CX-3 - Page 356

(With Mazda Radar Cruise Control
(MRCC) or Mazda Radar Cruise
Control with Stop & Go function
(MRCC with Stop & Go function))
To decrease the set speed, press the
SET
switch continuously. The set
speed can be adjusted in 10 km/h (5
mph) increments. The set speed can
also be adjusted in about 1 km/h (1
mph) increments by pressing the SET
switch momentary. For example, the
set speed decreases about 4 km/h (4
mph) by pressing the SET
switch 4
times.
NOTE
x
(With cruise control)
When the vehicle set speed is displayed
in the instrument cluster, press the RES/
switch to set the displayed vehicle
speed.
(With Mazda Radar Cruise Control
(MRCC) or Mazda Radar Cruise
Control with Stop & Go function
(MRCC with Stop & Go function))
When the vehicle set speed is displayed
in the instrument cluster, press the RES
switch to set the displayed vehicle speed.
x
The system is temporarily cancelled
when the vehicle is accelerated by
depressing the accelerator pedal
strongly, however, it resumes when the
vehicle speed decreases to the set speed
or less.
x
The vehicle speed may exceed the set
speed on a down slope.
▼
Temporarily Ca nce lli ng the System
The system is temporarily cancelled
(stand-by status) when any of the
following operations is done while the
ASL is displayed.
x
OFF/CANCEL switch is pressed
x
Accelerator pedal is strongly depressed
With cruise control
Press the RES/
switch to resume the
operation at the previous set speed. The
ASL display remains displayed.
With Mazda Radar Cruise Control
(MRCC) or Mazda Radar Cruise
Control with Stop & Go function
(MRCC with Stop & Go function)
Press the RES switch to resume the
operation at the previous set speed. The
ASL display remains displayed.
NOTE
x
(With cruise control)
The set speed can be set by pressing the
SET/
switch while the system is in
stand-by status.
(With Mazda Radar Cruise Control
(MRCC) or Mazda Radar Cruise
Control with Stop & Go function
(MRCC with Stop & Go function))
The set speed can be set by pressing the
SET
or SET switch while the system
is in stand-by status.
x
The ASL is not cancelled by depressing
the brake pedal.
When Driving
i-ACTIVSENSE
4-171
CX-3_8GT4-EE-18D_Edition8_old 2019-11-14 12:53:52