Wiper Blades
CAUTION
¾Hot waxes applied by automatic car
washers have been known to
aect
the
wiper's ability to clean windows.
¾To prevent damage to the wiper blades,
do not use petrol, paran, paint thinner,
or other solvents on or near them.
¾When the wiper lever is in the AUTO
position and the ignition is switched ON,
the wipers may move automatically in
the following cases:
¾If the windscreen above the rain sensor
is touched.
¾If the windscreen above the rain sensor
is wiped with a cloth.
¾If the windscreen is struck with a hand
or other object.
¾If the rain sensor is struck with a hand
or other object from inside the vehicle.
Be careful not to pinch hands or
ngers
as it may cause injury, or damage the
wipers. When washing or servicing the
vehicle, make sure the wiper lever is in
the OFF position.
Contamination of either the windscreen or
the blades with foreign matter can reduce
wiper effectiveness. Common sources are
insects, tree sap, and hot wax treatments
used by some commercial car washes.
If the blades are not wiping properly, clean
the window and blades with a good
cleaner or mild detergent; then rinse
thoroughly with clean water. Repeat if
necessary.
▼
Replacing Windscreen Wiper Blades
When the wipers no longer clean well, the
blades are probably worn or cracked.
Replace them.
CAUTION
To prevent damage to the wiper arms and
other components, do not try to sweep the
wiper arm by hand.
NOTE
When raising both windscreen wiper arms,
raise the driver's side wiper arm first.
When lowering the wiper arms, slowly
lower the wiper arm from the passenger's
side first while supporting it with your
hand. Forcefully lowering the wiper arms
could damage the wiper arm and blade,
and may scratch or crack the windscreen.
Replace the wiper blades using the
following procedure.
1. Raise the wiper arm.
2. Open the clip and slide the blade
assembly in the direction of the arrow.
Maintenance and Care
Owner Maintenance
6-33
CX-3_8GT4-EE-18D_Edition8_old 2019-11-14 12:53:52
To Next Page
Loading...
