Mazda CX-3 - Page 625

3. Tilt the blade assembly and remove it
from the arm.
CAUTION
To prevent damage to the windscreen
let the wiper arm down easily, do not
let it slap down on the windscreen.
4. Pull down the blade rubber and slide it
out of blade holder.
5. Remove the metal stiffeners from each
blade rubber and install them in the
new blade.
CAUTION
¾Do not bend or discard the
stieners.
You need to use them again.
¾If the metal stieners are switched,
the blade's wiping eciency could be
reduced.
So do not use the driver's side metal
stieners on the passenger's side, or
vice versa.
¾Be sure to reinstall the metal
stieners
in the new blade rubber so
that the curve is the same as it was in
the old blade rubber.
6. Carefully insert the new blade rubber.
Then install the blade assembly in the
reverse order of removal.
Maintenance and Care
Owner Maintenance
6-34
CX-3_8GT4-EE-18D_Edition8_old 2019-11-14 12:53:52