Key Battery Replacement
If the buttons on the transmitter are
inoperable and the operation indicator
light does not flash, the battery may be
dead.
Replace with a new battery before the
transmitter becomes unusable.
CAUTION
¾Make sure the battery is installed
correctly. Battery leakage could occur if it
is not installed correctly.
¾When replacing the battery, be careful
not to touch any of the internal circuitry
and electrical terminals, bend the
electrical terminals, or get dirt in the
transmitter as the transmitter could be
damaged.
¾There is the danger of explosion if the
battery is not correctly replaced.
¾Dispose of used batteries according to
the following instructions.
¾Insulate the plus and minus terminals
of the battery using cellophane or
equivalent tape.
¾Never disassemble.
¾Never throw the battery into re or
water.
¾Never deform or crush.
¾Replace only with the same type battery
(CR2025 or equivalent).
The following conditions indicate that the
battery power is low:
x
The KEY indicator light (green) flashes
in the instrument cluster for about 30
seconds after the engine is switched
OFF.
x
The system does not operate and the
operation indicator light on the
transmitter does not flash when the
buttons are pressed.
x
The system's operational range is
reduced.
Replacing the battery at an expert repairer
(we recommend an Authorised Mazda
Repairer), is recommended to prevent
damage to the key. If replacing the battery
by yourself, follow the instruction.
Replacing the key battery
1. Press the knob and pull out the
auxiliary key.
Knob
2. Twist a tape-wrapped flathead
screwdriver in the direction of the
arrow and open the cover slightly.
Cover
Maintenance and Care
Owner Maintenance
6-40
CX-3_8GT4-EE-18D_Edition8_old 2019-11-14 12:53:52