85
Audio Operation
n Radio ON
1.Press the SOURCE button.
2.Select the or on-screen button to turn the radio on.
n Band selection
Choose AM by pressing the on-screen button and FM by pressing the on-screen
button.
The selected mode will be indicated. If FM stereo is being received, STEREO will be
displayed.
n Tuning
The radio has the following tuning methods: Manual, Seek, Scan, Preset channel,
PTY(Program-type information) tuning, and Auto memory tuning. The easiest way to tune
stations is to set them on preset channels.
Note
lIf the FM broadcast signal becomes weak, reception automatically changes from STEREO
to MONO for reduced noise, and the STEREO indicator will go out.
lPress the MAP button to switch to the map screen.
lIf the power supply is interrupted (fuse blows or the battery is disconnected), the preset
channels will be canceled.
n Manual tuning
Turning the TUNE AUDIO dial will change the frequency higher or lower.
n Seek tuning
Pressing and holding the SEEK/TRACK button ( , ) will cause the tuner to seek a
higher or lower frequency automatically.
Operating the Radio
LOAD/
PUSH
POWER
PUSH
AUDIO
VOL
SOURCE
SCAN
SEEK
TRACK
MAP
DISP
MENU
VOICE
RETURN
TUNE
Channel preset on-screen button
SCAN button
SOURCE button
TUNE AUDIO dial
AUTO-M on-screen button
To Next Page
Loading...
Need help?
General
