Preventative Maintenance
To insure optimum performance, the machine must be kept clean
and well maintained.
With reasonable care, this machine will give years of service.
Therefore, it is important that a regular schedule of preventive
maintenance be kept.
Store machine inside, out of the weather, whenever possible.
TX00428-8-10-95
Pivot Pins and Shafts
Occasionally add a drop of oil to pivot pins and shafts.
TX00864-1-30-96
Maintenance
Cleaning the Machine
Clean the machine with a soap and water wash as needed.
Remove the heater and facer from the spray area before
cleaning.
TX00862-1-30-96
Clean and Lubricate Guide Rods
Remove oily dirt buildup from guide rods using WD-40
®
or
similar solvent and wipe guide rods clean. Do not leave the
cleaning agent on the guide rods.
Remove the 1/16" pipe plugs on each side of the moveable jaw.
Lubricate guide rod bushings with SAE 10W-40 motor oil through
the oil holes on the movable jaw. Replace the pipe plugs.
TX00863-1-30-96
CD00142-11-2-94
CD00178-5-3-96
PH01865-7-25-00
PH01864-7-25-00
4 - 1
To Next Page
Loading...