McElroy Sidewinder - Operation; Fitting Installation and Seating

4 - 3
Seating the Fitting
Make sure the fitting is seated properly on the pipe and tighten
the pivot release master insert enough to secure the fitting in the
unit.
NOTICE: Do not overtighten.
Release the machine pressure.
Tighten Fitting Cap
If the fitting has a cap, tighten the cap before installing in pivot
release master insert assembly.
Installing the Fitting
Insert fitting into pivot release master insert or movable jaw without
clamping on it. Release the drive screw and push the fitting down
to the pipe.
Operation
PH00828-8-15-96 PH00826-5-3-96PH00786-4-3-96
TX00927-5-7-96
TX00925-7-30-10
TX00926-7-30-10
PH00827-5-3-96