5 - 1
Maintenance
Lubricate Wipers, Seals and Bearings
The rubber wipers and seals on the jaw require occasional light
lubrication with 30W or lighter oil to keep them flexible and in
good working order.
Remove guide rod support plate. Slide movable assembly up to
expose linear ball bearings (Do not completely remove from the
guide rods). Apply oil to the ball bearings.
Slide the movable jaw down and attach the guide rod support
plate.
Washing the Machine
The machine should be cleaned, as needed with a soap and
water wash.
Do not pressure wash.
Clean Guide Rods
Remove accumulated dirt and grit from guide rods using
WD-40
®
or similar solvent and wipe guide rods clean.
Preventative Maintenance
To insure optimum performance, the machine must be kept clean
and well maintained.
With reasonable care, this machine will give years of service.
Therefore, it is important that a regular schedule of preventive
maintenance be kept.
Store machine inside, out of the weather, whenever possible.
CD00142-11-2-94
CD00178-5-3-96PH00830-5-3-96
PH00830-5-3-96
TX00428-8-10-95
TX00429-04-28-14
TX00910-9-22-10
TX00911-9-22-10
To Next Page
Loading...
