6 - 1
Maintenance Checklist
Fusion Machine Checklist
Item to Check Satisfactory Needs Repair Comments
Repair
UNIT
Machine is clean
All pins and snaprings are in place
All nuts and bolts are tight
All placards and handles are in place
All clamp knobs turn freely
All hardware is on the basic machine
Machine is free of leaks
Hydraulic gauge reads correctly
Jaws are properly aligned
Inserts fit and pin properly
Drive screw rotates freely
System holds pressure
Load cell contain proper amount of hydraulic fluid
HEATER
Cord and plug are in good condition
Heater surface is clean and in good condition
Thermometer is in good working order
Surface temperature checked with pyrometer
TX04105-6-28-10
To Next Page
Loading...