McIntosh MX130

10. Press MUTE to mute the audio signals
separately in either Area "A" or "B". Area "A"
muting is indicated by the front panel LED above
the VOLUME control blinking on and oft. To un-
mute Area "A", press MUTE a second time, press
an UP ( ) or DOWN ( ) VOLUME pushbutton or
turn the front panel VOLUME control.
Area "B" muting is indicated by the LED in
a wall sensor or keypad blinking on and off. To
unmute Area "B", press MUTE again or press
an UP ( ] or DOWN ( ) VOLUME pushbutton.
11. SP (Surround Processor) pushbutton
switches Area "A" surround signal processing
functions IN or OUT in HALL, CINEMA 1 or
CINEMA 2 modes. When signal processing is
switched OUT, the MX130 returns to normal
STEREO operating mode.
An LED above the front panel SURR PROC
pushbutton turns on to indicate when signal pro-
cessing is active.
12. Press either the UP ( ) or DOWN ( ) SURROUND pushbutton to calibrate individual chan-
nel level balance during surround sound calibration procedure on all six channels. You can
also raise or lower the surround sound levels during normal operation with these pushbuttons.
13. Press UP VOLUME ( ) to raise the listening volume and DOWN VOLUME ( ) to lower
the listening volume. All six channels are affected.
The VCR1, VCR2, TAPE1, TAPE2 and Area "B" Outputs are not affected by the remote volume
pushbuttons.
14. Press ACC (ACCessory) OFF or ACC ON to control the AC Power of an accessory com-
ponent that is being used in combination with an RCT-1 Remote Control Translator.
HOW TO INSTALL BATTERIES IN THE MX130 HAND HELD REMOTE CONTROLLER
Slide open the battery compartment. Insert two type AA batteries into the compartment,
making sure to observe the battery polarities Indicated in the battery compartment.
When the batteries are nearing exhaustion, the effective range of the remote controller
decreases, and MAY even fail to operate. In this case, replace both batteries with fresh ones.
NOTE:
1. Do not mix old and new batteries. Use ONLY batteries that are new.
2. Make sure both batteries are of the same type and identical.
3. To prevent damage caused by possible battery leakage, remove the batteries from the
remote controller if it is not going to be used for an extended period of time.
4. Never dismantle batteries or dispose of them in a fire, as they may explode. Dispose of
old batteries in an approved method for proper safety.
MX130
HAND HELD
REMOTE
CONTROLLER
17