EasyManua.ls Logo

MDC XT 14E 2021 - Trailer Lights & Charging While Driving

MDC XT 14E 2021
101 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.marketdirect.com.au
I
Ph: 1300 494 494 I ©Copyright Page | 14
Trailer Lights
Plug Type 12 Pin Flat (Not Negotiable)
Charging Camper/Caravan While Driving
Plug Type 50 amp Anderson Plug.
Vehicle with or without smart alternator:
The Anderson plug can be connected to the start battery on the vehicle and should include the following
to protect the start battery.
1. 50 amp relay to stop power supply when vehicle is not running.
2. 50 amp fuse or circuit breaker at the battery
Notes: The Projecta IDC25L DC to DC controller fitted in your MDC trailer is programmed to
favour the solar panel input exclusively until it drops below a threshold voltage input. By
providing accessory power to the number 12 pin, the trigger for the IDC25L will be set off to take
power from both the Anderson plug and the solar panels. It will also trigger the IDC25L to activate
the vehicle’s ECU to make the alternator provide power to fully charge the multiple batteries in
your Caravan.

Table of Contents

Related product manuals