Meaco Arete Two 20L - Storing; Troubleshooting

[EN] 19
Storing
If the dehumidier will not be used for a long period of time, take the following steps:
1. Run the dehumidier in Air Purication Mode for a few hours to dry the internals as much as possi-
ble. This will help to minimise the chance of mould growing inside the dehumidier during long term
storage.
2. Remove the plug from the socket and empty the water tank. Allow the water tank and the dehumid-
ier to dry completely, this can take a couple of days.
3. Use the cable tidy on the back of the dehumidier to wrap the cable away.
4. Clean the lter and store the device in a dust-free location away from direct sunlight, preferably
covered with a sheet of plastic.
Troubleshooting
If you come across a problem with your dehumidier, check the table below and try the suggestions. If
the problem persists, contact Meaco.
Error Action
Dehumidier indicator is not displayed
The dehumidier is checking the humidity level to see if it has
risen above the set target.
Buttons do not beep when pressed
The dehumidier is in Night Mode. To remove Night Mode
press the Night Mode button twice.
There are no lights on the display
The dehumidier is in Night Mode. To remove Night Mode
press the Night Mode button twice.
The dehumidier does not dehumidify /
collects little water
• The temperature is either too cold or too warm, make sure
the dehumidier is being used in an environment between
5°C and 35°C.
• The humidity level is already very low – below 45%RH
the dehumidier will not collect much water as there isn’t
enough moisture in the environment.
• The target humidity level is higher than the actual humidity
level. Use the Smart Humidity Mode button to reduce the
target humidity level.
• Clean the dust lter and/or replace the H13 HEPA lter. If
these are dirty they will block the airow and prevent the
dehumidier from dehumidifying.
• The dehumidier is in Air Purication Mode. See page 12 for
more information.