32
Aligning The Red-Dot Viewfinder
Aligning the red-dot viewfinder allows you to accurately point at the same location as the telescope. It is
recommended that you perform steps 1 and 2 during the day and step 3 during nighttime.
NOTE: THE RED-DOT FINDER IS ONLY FOR NIGHTTIME USE
AND SHOULD NEVER BE USED AT OR NEAR THE SUN.
STEP 1: Point telescope at an easy-to-find target.
NOTE: DO NOT EVER POINT AT OR NEAR SUN WITHOUT THE PROP-
ER SOLAR FILTER INSTALLED!
STEP 2: Look through the 26mm eyepiece and turn the fo-
cuser knob until the image is sharply focused. Center the object
precisely in the eyepiece’s field of view.
STEP 3: Turn on the red-dot viewfinder by turning the on/off
switch clockwise.
Step 2.
Step 3.
31
To Next Page
Loading...
