Mec 4069 RT - Electrocution Hazard

Page 4 93075
April 2014 4069 RT
4069 RT Safety
Electrocution Hazard
ELECTROCUTION HAZARD! THIS MACHINE IS NOT INSULATED!
DEATH OR SERIOUS INJURY will result from contact with or inadequate clearance from any electrically
charged conductor.
You must maintain a CLEARANCE OF AT LEAST 10 FEET (3.05 m) between any part of the machine, or its
load, and any electrical line or apparatus carrying over 300 Volts up to 50,000 Volts. One foot (30.5 cm)
additional clearance is required for every additional 30,000 Volts.
Observe Minimum Safe Approach Distance.
DO NOT work in close proximity to, or in contact with, energized power lines and electrical
equipment. This machine is not insulated and WILL NOT protect the operator from injury or
the machine from damage.
Refer to the following diagram and all applicable governmental regulations for the minimum
safe distances from energized power lines and electrical equipment.
DO NOT touch the machine if it contacts energized power lines.
Personnel in the platform:
• Move away from the platform rails,
• DO NOT attempt to operate the machine, and
• DO NOT touch any part of the machine until energized power lines are shut
off.
Personnel on the ground:
•DO NOT approach the machine and
• DO NOT touch or attempt to operate the machine until energized power
lines are turned off.
Do not operate the machine during electrical storms or lightning.
DO NOT use the machine as a ground for welding unless properly equipped with a
weld-line-to-platform option.
Art_2824
Art_2823