Page 14 1330SE - Operator’s Manual
June 2023
Workplace Inspection
DO NOT operate this machine until you have read and understood this manual, have
performed the Workplace Inspection, Pre-Start Inspection and Routine Maintenance, and have
completed all the test operations detailed in the Operating
Instructions section. Inspect the workplace and determine whether the workplace is suitable for safe
machine operation. Do this before moving the machine to the workplace.
Be sure the lift is the correct machine for the job.
Be aware of workplace conditions, and continue to watch for hazards while operating the machine.
Workplace Inspection
Before operating the machine, check the workplace for all possible hazards, including but not limited
to:
• Drop-os or holes, including those concealed by water, ice, mud, etc.
• Sloped, unstable or slippery surfaces
• Bumps, surface obstructions and debris
• Overhead obstructions and electrical conductors
• Other objects or equipment
• Hazardous locations and atmospheres
• Inadequate surface and support to withstand all load forces imposed by the machine
• Wind and weather conditions
• The presence of unauthorized personnel
• Other possible unsafe conditions
Section 6 - Workplace Inspection
Workplace Inspection
To Next Page
Loading...
