Page 31 1330SE - Operator’s Manual
June 2023Section 9 - Maintenance
Frequent Inspection Checklist
This checklist must be used at 3-month intervals or every 150 hours of
machine use, whichever occurs rst. Failure to do so could result in
death or serious injury.
Frequent Maintenance Inspections should be conducted by qualied service technicians only.
Photocopy this page for reuse. Keep inspections records up to date. Record and report all
discrepancies to your supervisor. See the Service & Parts Manual for specic instructions.
Model Number Serial Number Hour Meter Reading
Perform all checks listed on Pre-Start Inspection.
Inspect the condition of hydraulic uid in the reservoir. Oil should be a clear and amber in color.
Batteries
Electrical wiring
Tires and wheels
Emergency stop
Key switch
Horn (if equipped)
Drive brakes
Drive speed - stowed
Drive speed - raised
Drive speed - slow
Hydraulic oil analysis
Tank venting system
Additional maintenance requirements for severe conditions
If the machine is used in very dusty, exceptionally hot or exceptionally cold conditions, replace
the Hydraulic Cap Breather Filter (under normal conditions replace every 6 months or 300 hours,
whichever comes rst).
Date Inspected By
To Next Page
Loading...
