Page 12 92RT Scissor Lifts - Operator’s Manual
July 2020
Function Tests
DO NOT operate this machine until you have read and understood the Safety section of this
manual, have performed the Pre-Start Inspection, Routine Maintenance, and Functions Test,
have inspected the jobsite for hazards, and have learned the operating procedures for this
machine.
The operator must conduct a Functions Test of the machine before each work shift to check that all
machine systems are working properly.
Test the machine on a firm level surface with no debris, drop-offs, potholes or overhead obstructions.
Perform each step outlined in Operating Instructions on page 13.
DO NOT use a machine that is malfunctioning. If any function does not perform as described, tag the
machine and remove for repair by a qualified service technician. After repairs are completed, a Pre-
Start Inspection and Functions Test must be performed before using the machine.
Section 6 - Function Tests and Operating Instructions
Function Tests
To Next Page
Loading...
