EN
21
05
Û
CLEANING AND STERILIZATION
Delicately brush the surface of the wrench
with a brush with soft nylon bristles using
distilled water;
Lubricate with medical degree lubricant in
the indicated point;
Dry the wrench with a soft cloth
with low fiber-release;
8
10
9
11
12
Once you’ve finished the cleaning
operations, check the wrench under an
adequate source of light, paying attention
to the details that could conceal dirt
residues (cavities, grooves) and, if need be,
repeat the cleaning cycle;
Seal the wrench individually in a single-use
sterilization packet.
Sterilize the wrench in a steam autoclave;
CAUTION:do not use lubricants
based on oil or silicon.
To Next Page
Loading...
