mectron Piezosurgery touch - Cleaning and Sterilization of the Handpiece Mobile Support

EN
28
STERLIZATION METHOD
Irrigation bag support rod and handpiece fixed support
The sterilization process in steam autoclave
must be performed setting the parameters
indicated below, which are validated by
Mectron and reach the sterilization safety
levels (SAL 10
-6
):
- 3 times Pre-vacuum
(minimum pressure 60 mBar).
- Sterilization temperature 132°C
(interval 0°C ÷ +3°C).
- Sterilization time 4 minutes.
- Minimum drying time 10 minutes.
All the sterilization phases must be performed
by the operator in compliance to the norms
UNI EN ISO 17665-1:2007, UNI EN ISO
556-1:2002 e ANSI/AAMI ST 46:2002.
WARNING: Checking infections - Parts
that can be sterilized - Diligently remove
all residues of organic dirt before the
sterilization.
CAUTION: Perform the sterilization
using a water steam autoclave only. Do not
use any other sterilization procedure (dry
heat, irradiation, ethylene oxide, gas, low
temperature plasma, etc.).
CAUTION: Do not exceed the allowed
load of the steam sterilizer.
05.9
Û
CLEANING AND STERILIZATION OF THE HANDPIECE
MOBILE SUPPORT
MATERIALS NECESSARY
- Enzymatic detergent with pH 6-9
- Water
- Container for the immersion in the
enzymatic solution
- Distilled water
- Single-use sterilization packets
- Steam sterilization
CAUTION: Do not use hydrogen
peroxide. If you intend to disinfect the
support, do not use hydrogen peroxide, but
only disinfectants with neutral pH (pH7);
always rinse with sterile water to preserve
the disinfection.
CAUTION: Once used, correctly dispose
of the enzymatic detergent solution, do
not recycle.
PREPARATION
- Take the handpiece mobile support.
CLEANING AND DISINFECTION METHOD - Handpiece mobile support
Prepare an enzymatic detergent solution
with pH 6-9, as per the instructions of the
manufacturer;
1