mectron Piezosurgery - ASSEMBLY, CONFIGURATION, AND USE; Pre-Use Safety Checks

13
EN
06 CLEANING OF THE ACCESSORIES
06.1 MANUAL/AUTOMATED CYCLE
06.1.1 MANUAL PRE-WASHING AND CLEANING WITH
ENZYMATIC DETERGENT
HANDPIECE WITH CORD
NOTE: Choose between the following
cleaning methods.
In case the practice is not equipped with
a thermodisinfector, the cleaning process
can begin with the manual pre-washing
(paragraph 06.1.1) and proceed with the
sterilization (Chapter 09).
In case the practice is equipped with a
thermodisinfector the pre-washing can be
performed manually (paragraph 06.1.1) or
FDQEHDXWRPDWHG&KDSWHU7KHÀQDO
step is always the sterilization (Chapter
09).
CAUTION: The following instructions
have been validated by the medical
device manufacturer as ABLE to reprocess
a medical device for being reused. It is
up to the process responsible to assure
that the repeated processes are actually
performed by means of equipment,
materials and personnel structured as
repeated processes in order to obtain the
desired result. Generally this requires the
validation and the systematic monitoring
of the process. Similarly, in case the
person in charge of the process deviates
from the supplied instructions, he shall
properly evaluate any action and their
HIÀFLHQF\DQGWKHSRVVLEOHXQGHVLUHG
consequencies.
1
2
Prepare an enzymatic* detergent solution
with pH 6-9, as per the instructions of the
manufacturer;
CAUTION: Once used, correctly
dispose of the enzymatic detergent
solution, do not recycle.
Clean the surface of the handpiece and
of its cord with a clean, soft cloth with
ORZÀEHUUHOHDVHGDPSHQHGZLWKD
detergent solution (pH 6-9) and, if you
wish to disinfect use a non-aggressive
disinfectant solution with neutral pH (pH7),
following the instructions provided by the
manufacturer of the solution;