Disassembly and Assembly
52
3) Remove the three small pan head screw+spring washer assemblies that fasten the drive head
board, and then take down the drive head board (3).
4) Remove the two small pan head screw+spring washer assemblies that fasten the claw motor,
and take down the HP-30 claw motor assembly (7). To dismantle only the pressure sensor,
ignore steps 2 and 3.
5) Remove the two small pan head screw+spring washer assemblies that fasten the pressure seat
end cover, dismantle the HP-30 pressure seat end cover, and then take down the HP-30
pressure sensor (1).
To Next Page
Loading...
