Setup
7
B. Put the foot pedal unit(4) in between the left and right legs
components (2&3), use 4 pieces of screws (8)(2 on each side) to
stable the legs onto the foot pedal unit. (Make sure the direction of
the placement is correct before screwing)
C. Use 8 pieces screw(9), make the Rear board fixed on the Foot
pedal unit(4) and right leg component(3), the left leg component(2)
finished in part A on the previous page.
D. Put the piano body(1) on the top of the assembly finished in part B,
use 2 pieces of hand screws (7) and 2 pieces of screws (6) to stable
afterward.
To Next Page
Loading...
